delete

What You Should Know about Circuit Breakers and Fuses

When it comes to electrical systems, fuses and circuit breakers are the ones that require the most attention. This is because they tend to trip often. It’s important to use the right amperage or you will have problems. Correcting wiring and voltage is the key to proper circuit safety.

It’s important to have the right number of circuits to accommodate every single one of the electrical equipment that you have in your home. Don’t hesitate to consult electricians or the power supply company for assistance. They will tell you if you need larger service loads. If you need to rewire your electrical circuit, you have to develop the right wiring layout recommended by an electrical specialist.

Identify Your Circuitry

Electrical contractors should be present in every home construction project. The electrician will identify the circuit and conductor size in order to install the right fuse size. Ask the electrical contractor what his recommendations are and attach it as a record inside the service panel. Be sure to have each circuit described, identified, and numbered.

Always get that record whenever you’re installing new wiring systems. If your home wiring circuit isn’t properly identified, then you will consume time in making up that record. Such time could have been used to install fuse replacements and do fixture alterations. Other repairs may also be affected until such record is defined. Either way, you need to consult with an electrician to get everything right.

Proper Fuse Protection

Over fusing happens when your electrical system becomes vulnerable. It’s that time when loaded wires start to overheat. Once the insulation flakes off and hardens, the conductors carrying current becomes bare. When wires overheat, they burn wood, dust, and paint. That’s how fire caused by electrical current starts.

To make sure that none of those will happen, proper fusing is necessary. Proper fuse protection is your guard against hazards. Installing the right tamper-proof fuse is the logical solution, as it is also a protective device.

Types of Fuses Available

There are three types of fuses available these days and one of them is the ordinary fuse. Then there’s the Edison-base dual-element fuse with time delay and the dual-element, time-delay, and tamper-resistant Type-S fuse that also comes with an adapter.

1. Ordinary Fuse

The use of ordinary fuses is highly recommended as replacements. It’s mostly used for circuits serving heating loads and incandescent lights. These fuses will have their ampere rating marked clearly either on the top or bottom. The problem with ordinary fuses is the time lag that is built into them. Because of that, their purpose is not satisfactory for use on circuits serving appliance motors.

2. Edison-base fuse

The Edison-base fuse is designed mainly for circuit protection. Its dual element and time-delay feature are essential to achieve circuit protection. They allow momentary yet normal motor overloads all without getting the fuse all blown up. Even so, the fuse link will blow once short circuits ensue.

3. Type S fuse

This fuse is the best type available. The latest local codes require the use of this type, more particularly in a service panels. These devices makeover fusing very difficult. Type-S fuses require an adapter to work. To install this type of fuse in your home, hire the best electrical contractors St. Louis to help you out.